IES 8605 INTERMIX 10 GRAY BARE METAL SEAM SEALER/ADHESIVE 6.76OZ/200ML,NON-SAG

Description

INTER-MIX 10 “Thick-Set” Adhesive/Seam Sealer
Is a non-sagging, firm, semi-flexible, adhesive/sealant designed for sealing vertical and horizontal seams and joints on automobiles and truck applications.
May be applied to bare metal and primed sheet metal joints.
Excellent adhesion to:
bare metal
primed metal
SMC
FRP
fiberglass
aluminum
most plastics
Can be sprayed with our 2K Spray System
• Can Be Applied to Bare Metal!
• Can Be Feather-Edged.
• Corrosion Protection.
DIRECTIONS
1. Surface must be clean and free of dirt, grease, oil, rust, old seam sealer and any other contaminants.
2. Apply directly to bare metal, epoxy or urethane primed surface.
3. Follow the IES dual cartridge set up instructions for loading cartridge into the dispensing gun.
4. Dispense IES Bare Metal Seam Sealer into the joint or seam. Smooth out if desired with tool, finger or brush.
5. IES Bare Metal Seam Sealer will set up in approximately 10 minutes.
6. Scuff or sand sealer with 320 grit sandpaper prior to priming or painting.
7. Prime and paint per manufacturer’s specifications.
PROPERTIES
Mixed Color GRAY
Mix Ratio 1:1
Work Time 10-15
Minutes
Handling Time 20-30 Minutes
Part Paintability 45 Minutes
Sealer Sandability 45 Minutes
Full Cure Strength 6-8 Hours 1500 Hour Salt Fog Test Passed (ASTM-B117)
All times stated are approximate depending on temperature and humidity. All times are based on 70°F to 75°F at 50% relative humidity